: Measure the signal between Pin 2 (signal) and Pin 1 (ground). Use a voltmeter at test point MP4 on the main board. 2. Angle Sensor Adjustment
Below is a guide for the assembly and maintenance procedures typically associated with these technical standards. 🏗️ PAT/Hirschmann Crane System Guide n_031.mp4
: Set the boom between 0 and 5 degrees. Use an inclinometer to verify the actual physical angle. : Measure the signal between Pin 2 (signal)
The angle sensor ensures the crane's boom is at the correct pitch for safe lifting. n_031.mp4
: Remove old wires from the terminal block and connect the new assembly.