: This is usually the first piece installed. Cut it to the width of the opening using a hacksaw. Secure it to the top jamb or ceiling header using screws, ensuring it is perfectly level. Lower Track :
: If your kit includes stoppers or soft-close mechanisms, slide them into the top track and tighten them at the points where the doors should stop. Recommended Tools Level and tape measure Drill with pilot bits Hacksaw (to trim tracks) Screwdriver (for adjustment screws) Installing a Sliding Closet Door Track
Lift the (the one further inside the closet) first. instruktsiia po ustanovki dveri kupe
For , you may use a small floor guide instead of a full track to keep the threshold clear. 3. Hanging the Doors
: Screw the roller brackets to the top (and sometimes bottom) of the door panels, usually 1–1.5 inches from the side edges. Mount the Panels : : This is usually the first piece installed
: Typically, the combined door panels should be at least 10 cm wider than the opening to provide a sufficient overlap when closed. 2. Installing the Tracks
: Turning these screws clockwise or counter-clockwise will raise or lower that side of the door to make it plumb. Lower Track : : If your kit includes
: Measure the opening in three places (top, middle, bottom for width; left, center, right for height).