A_feladat_1_start.pkt 90%

Refer to the "Addressing Table" provided within the lab instructions to assign addresses.

To ensure end-to-end communication between different networks:

: Use the ping command from a PC's command prompt to test connectivity to other devices. 4. Troubleshooting Checklist If connectivity fails (pings do not succeed): A_feladat_1_start.pkt

Console password: line con 0 , then password cisco and login . VTY lines: line vty 0 4 , then password cisco and login .

: On routers, enter interface configuration mode (e.g., interface g0/0 ), set the address ( ip address [IP] [Mask] ), and enable it with no shutdown . Refer to the "Addressing Table" provided within the

: If routers cannot see all networks, add routes using the ip route [Destination Network] [Mask] [Next-Hop IP] command.

: On switches, configure interface vlan 1 with an IP address and no shutdown . 3. Routing and Connectivity : If routers cannot see all networks, add

While the specific instructions for every variation of "A_feladat_1" can vary, these "start" files typically require a standard set of core configurations to establish basic network connectivity. Core Configuration Tasks